Product Name: Automatic Pet Water Fountain Dispenser
Size 180 * 180 * 155MM
Weight:1100g (including a filter element;Not include Intelligent add warmer)
Material: outer wall ABS (white polishing) ;inner barrel food grade ABS (frosting)
Product include:1set Smart Pet Drinking Water Drinker (include 1pcs Filter, 1pcs Filter Foam,1pcs Filter Tray)
Not include: 1pcs Thermostat (Option)
1. Take out the water storage tray and filter element tray
2. Fully immerse the new filter element in water for 10 minutes and wash it. It is recommended to repeat twice.
3. Put the filter element unit into the filter element tray
4. Take out the power adapter and insert it into the round hole socket at the bottom of the host
5. Short press the front button of the host to start the machine
6. Press the key briefly to switch the working mode in the power on state
>Filter replacement instructions
1. It is recommended to replace the filter element once a month to achieve good filtering effect. Replace filter element once every 3 months in intelligent mode)
2. Soak the new filter element in clean water for 10 minutes (to activate the ion exchange resin) before use.
3. After replacing the filter element, press and hold the reset key at the bottom of the machine body for 5 seconds until the orange light goes out. *New filter elements need to be purchased separately
Water Flow is smarter than you think
It improves the frequency of water outflow in smart and normal mode, and the higher frequency of water outflow promotes the cat’s Drinking water consumption
Normal mode: continuous water spray,flow water
Smart mode: High frequency water spray during the day, intermittent work at night
*About 1 kwh in 3 months in smart mode
White – normal operation; orange – change filter; blue – water shortage Tips
12V low pressure mute water pump, with unique water circulation design, effectively reduces noise to 40dB
Worried about the decline of pet drinking water in winter? Research shows that drinking warm water can reduce physical loss. The 2 generation intelligent water dispenser is connected with external heater, which rapidly heats up to 10 ° C according to the ambient temperature, takes care of pet’s intestines and stomach, and maintains the daily water demand.
*Intelligent heater needs to be purchased separately
>Operation instructions of heater
1. After the heater is used, there may be scale on the heating components, which belongs to normal phenomenon and can be used normally
2. The heating temperature of this product is not more than 25℃. Due to the high temperature of human body, it may not be obvious. The lower the ambient temperature is, the more obvious the temperature sensing effect of the heater is
Intelligent constant temperature heating mode
The heating components in contact with water are equipped with water temperature sensors, which can quickly respond to the ambient water temperature and conduct corresponding heating work.
|Temperature：T ℃||Heating mode|
|15-25||T heat to a maximum of 25℃
and maintain a constant temperature of 25℃
|>25||T, no heating|
*The maximum heating temperature can reach 25 ° C; the screen displays the current actual water temperature
>Installation method of filter cotton module
First, insert ∪ type cotton into the white component according to the specified direction, press and fix it, then insert the installed filter cotton component into the U-type card slot beside the water pump of the water dispenser for fixation, and then install the filter cotton component.
*The filter cotton in the white accessories needs to be replaced on a regular basis. Each replacement only needs to be installed according to the above steps
>Matters needing attention
the power adapter of heater and water dispenser cannot be used in series. Please make sure to use the corresponding special original adapter, otherwise it will cause equipment failure.
regularly check the size and accessories of the water dispenser, and make sure that the accessories are installed in place before each use.
observe the use of pets. If you find that pets are biting or dismantling the equipment, please correct the behavior of pets in time to avoid eating or damaging the equipment by mistake.
For the safety of you and your pet, please pay attention to the following operations:
1. Please use the machine in indoor environment
2. When cleaning the whole machine, please cut off the power supply
3. Please don’t let the pet chew the wire to avoid electric leakage
4. Children should operate the equipment under the guidance of adults
5. Keep it horizontal, do not overturn the equipment
6. When using the machine, keep the bottom of the water storage barrel and the metal shrapnel dry
7. The adapter of this product is 12V. Please do not use it for products with rated voltage.